The best sources for high quality sport fishing tackle

Archive for the ‘Pike fishing tackle’ Category

Pike Fishing using Fly Gear

Comments Off

I have spent a lot of my angling career fly fishing for trout.  This has been very enjoyable but is a pass time I now only do occasionally, perhaps when I go on holiday to Scotland or I very rarely if I fancy a morning by the lakeside.  The latter is now very infrequent as the local fishery where I used to whet the odd fly line Raker Lakes has now closed its put and take trout fishery and all its ponds are taken up as coarse fisheries.  I think that the problem was that the lakes were not suitable for the needs of the trout, but were fine for carp and other coarse fish whose requirements for highly oxygenated and cooler water were not so great.

So now if I fancy a bit of fly fishing on a summer evening I have to think of alternative venues.  I still would like to walk, cycle or at worst only have a quick five minute drive to a local venue to grab a couple of hours on a balmy evening.  So if I target pike in my local River Derwent which is just down the road I can still achieve this!

The type of sport fishing tackle I use for pike fishing not so very different to that used for trout fishing.  I use a heavier rod and line – in fact the one I hardly ever used that was intended for sea trout and grilse fishing.  It is an AFTM 8/9 setup with some strong backing on the reel.  I make the traces up with a 12 inch length of fine steel wire neatly whipped onto a small snap link at one end and fixed to 10 feet of 15 lb strain monofilant at the other.  This seems to work with the pike flies that I tie up myself.

The flies are not as big as some would use but a whole lot bigger than a typical trout lure.  The size does affect the casting even on the stronger gear.  However, because I am fishing the river my casting is usually restricted to about 10-15 yards using a stalking technique.

A typical pike fly with long tail

A typical pike fly with long tail

The takes can be quite spectacular and it is very satisfying catching even modest jacks.  Fish in the 5 to 12 pound bracket can provide huge entertainment!  Now that I have returned to pike fishing I will make sure that this method of catching pike is at the top of my list of things to do.

Pike Fishing Tackle – strength of fishing gear examined

Comments Off

For anybody considering pike angling then it would be useful to read this post about buying tackle specifically for hunting specimen sized predators.  The tackle generally used by many experienced anglers who seek this elusive quarry can on occasion be somewhat heavy.  By that I mean that the tackle is very strong and could safely handle large pike up to say 30 or 40 pounds in weight.

That is very well, but it can take a bit of the pleasure from your angling to sit by the river or lake with a broomstick connected to rope!

On the other hand, it would be irresponsible to go fishing knowing that there is a chance of catching say at least a 20 pound fish equipped with a sporting one pound test curve spinning rod and five pound breaking strain line!

So selection of the strength of your pike fishing tackle can add tremendously to the enjoyment of your sport.  I tend to go to my local water where I have caught pike up to 21 pounds with two rods with 1.5 pound test curves.  These are relatively light items as pike fishing tackle goes but I have found will handle the fish comfortably while feeling responsive in the hand.  These rods are ideally loaded with 12 – 15 pound breaking strain (nylon – or equivalent diameter of braid or fluorocarbon) and will feel balanced.

The fashion is for a 12 foot long rod which I actually like unless I am stalking a river bank.  Then I will use my ancient fibreglass 9 foot ABU spinning rod that can cast a few ounces of dead-bait happily.

The reel is less critical in my opinion – I use Shimano Bait Runners that will take around 200 metres of line.  This is more than enough.  A few years ago when I started specimen hunting for pike I bought one of these bait runners and paired it with an old Mitchell Match with automatic bail arm.  I used a deep spool of course – you could probably only fit 10 metres of suitably heavy line on the special match spool!  I caught many good pike, again up to 20 pound in weight, with this make shift partnership – even though it is definately not designed for the job!

The biggest factor in choosing gear – once you have read all the brochures about length, test curve, capacity of spool etc – is to simply get your preferred combination in your hand.  Do you like them?  As a committed tackle tart I must be in love with the gear.  Remember what fishing is about – as long as the pike fishing tackle is up to the job the important thing is your satisfaction.